1997 Johnson Evinrude "EU" 40 thru 55 2-Cylinder Service Manual, P/N 507265, Page 29Get this manual
New Engine Pre-Delivery Checks The careful preparation of an engine before delivery will ensure owner satisfaction1Upon uncrating new engine, inspect itIf you find: Shipping damagecontact the carrier that delivered it Parts or connections are looserepair as required Parts are missingcontact OMC
OWNER IDENTIFICATION CARD
Owner's Name Address
_ State _
Date of Purchase
2Before connecting the instrument harness to the outboard, verify operation of the OMC System Check T" engine monitor and other dash panel functions as described in Section 8, Circuit Verification, OMC Tester, PIN 4372743Verify oil tank is installed in relatively dry locationThe tank must not be exposed to constant rain or water spray4Install the outboard following procedures outlined in the Installation Guidelines5Check gearcase lubricant levelFill to oil level hole6Install test wheel and put engine into test tank1 7Momentarily pressurize the fuel systemCheck for leaks! Repair any leaks before continuing8Start engine and check cooling system operationBe sure engine warms to operating temperature at idle1 9Check shift operationCheck start-in-gear-prevention feature on engines so equipped110 Check electrical and ignition systems for stray spark sources11 Check all adjustmentsSee Synchronization and Linkage Adjustments, this section12With the engine at all trim angles, turn boat's steering wheel fully right and leftBe sure there is no interference of the steering connector, remote control cables, and electrical cables at the boat's motor well13Correct any problems found14Clean entire engine15Review Operator's Manual information, including owner's responsibilities and engine requirements