1997 Johnson/Evinrude EU 25, 35 HP 3-Cylinder outboards Service Manual, Page 235Get this manual
Installation
1Apply ONIC Locquic Primer and ONIC Nut Lock to the threads of the two starter mounting screws
2Position the starter and install the mounting screws Tighten to 15-17 ftIbs(20-23 Nm)
3Install top oil reservoir mounting screwTighten screw to
6-9 ftIbs(8-12 Nm)
rn 4with screw and ground studbracket to the engine and Attach electrical connector secure Tighten both to 60-84 in
Ibs(7-9 Nm)
5Attach ground wire and yellowred wire from neutral start switch to small posts on the bottom of the solenoidTighten nuts securely