1997 Johnson/Evinrude EU 25, 35 HP 3-Cylinder outboards Service Manual, Page 198Get this manual
15Use OMC Bearing Puller, PIN 432130, attached to OMC Slide Hammer, PIN 432128, to remove the forward bearing cupSecure the puller jaws into grooves behind the cup with jaws facing port and starboardUse OMC Wrench, PIN 334359to hold the puller while tightening the jaws16Use OMC Puller Bridge, PIN 432127, and OMC Small Puller, PIN 432131, to remove the driveshaft seals from the gearcase
INotellnspect bearings in placeIf bearing is removed for any reason, it must be replaced[] 17Remove the upper driveshaft bearing
and bearing sleeve from the gearcase using the same two toolsDiscard the bearing18To remove the pinion bearings, assemble the following components from OMC Universal Pinion Bearing Remover and Installer, PIN 391257:
PIN 326582 Rod PIN 326583 Pilot Plate PIN 326577 Remover and Installer 14-20 112 inHex Head Screw 14-20 114 inHex Head Screw CD in0.0Flat Washer