1997 Johnson/Evinrude EU 25, 35 HP 3-Cylinder outboards Service Manual, Page 180Get this manual
8Install the shift bellcrank into the exhaust housingMake sure the inside and outside bushings are seated
rn washer .the shift leverscrew tobellcrankSecure with screw 9Attach to the Tighten the 60-85 inIbs(7-10 Nm)and
10Verify that the shift rod connector is threaded down onto the rod until seatedBack off the connector until the connector is in line with the offset in the rodInstall the shift rod into the exhaust housingPosition the rod with the offset facing to the rear11Attach the shift rod to the bellcrank and secure with