1997 Johnson/Evinrude EU 25, 35 HP 3-Cylinder outboards Service Manual, Page 150Get this manual
InstallationRemote Models 1Coat both sides of new powerhead base gasket with OMC Gasket Sealing Compound and install it on the exhaust housing
2Coat the driveshaft splines with OMC Moly LubeDO NOT apply lubricant to the end of the driveshaft as lubricant here may prevent seating of driveshaft in crankshaft
3Attach QVIC Lifting Eye, PI 396748, to the flywheel and tighten the screws only enough to ensure thread engagementwill damage components mounted to the underside of the flywheel
INote Threading the lifting eye screws in too far into the flywheel
rn 4Using hoist, carefully seven screws coated with OMC lower the powerhead onto the exhaust housing Secure with