1997 Johnson/Evinrude EU 25, 35 HP 3-Cylinder outboards Service Manual, Page 146Get this manual
55Install one crankcase oiling hose recirculating hoses CD to the powerhead
and three
56Install all carburetion, ignition, and electrical components on the powerhead following instructions found in their respective sectionsInstallationTiller Models
1Coat both sides of new powerhead base gasket with OMC Gasket Sealing Compound and install it on the exhaust housing
2Coat the driveshaft splines Q) with OMC Moly LubeDo not apply lubricant to the end of the driveshaft as lubricant here may prevent seating of driveshaft in crankshaft3Attach OMC Lifting Eye, PI 396748, to the flywheel and tighten the screws only enough to ensure thread engagement&
INote Threading the lifting eye screws in too far into the flywheel