1997 Johnson/Evinrude EU 25, 35 HP 3-Cylinder outboards Service Manual, Page 139Get this manual
4Lubricate new driveshaft -ring and lightly lubricate crankshaft splines with OMC Moly LubeInstall a-ring in sleeve5Using external retaining ring pliers, install bearing retaining ring with sharp edge facing away from bearing
6Lubricate the two center main bearings and split sleeves with outboard lubricant and install them in their original positionsThe split sleeve ring grooves must face away from flywheel when installed
7Install the crankshaft seal ringsMake sure the ends of the seal rings overlap properly8Lightly apply OMC Gasket Sealing Compound on the metal case of new lower housing sealPosition the exposed lip of the seal into the lower housingPress against outer metal case ofthe seal until the edge of the metal case is flush with the inside surface of the lower housing