1997 Johnson/Evinrude EU 25, 35 HP 3-Cylinder outboards Service Manual, Page 97Get this manual
Installation
rn 1Installcrankshaft and key with its mark facing parallel to the flywheel outer edge centerline of single upset down2Clean the crankshaft and flywheel tapers with ave Cleaning Solvent and let dryThese surfaces must be clean and dry to allow proper locking of the tapers
rn 3Align the flywheel keyway and installSealing CompoundflywheelCoat the threads of the flywheel nut with OMC Gasket
Install the nut and torque to 100-105 ftIbs(136-142 Nm) using the flywheel holding tool as drawn on Page 3-6 and three PIN 309492 screws from ave Universal Puller Set, PIN 378103, or other suitable tool to hold the flywheel
INote After replacing any major ignition component, verify correct maximum spark advance using the procedure outlined in Section 1Encoder Servicing
m Check all the an accumulationofofdirtClean or replace the window styles the encoder for broken cracked corners or