1997 Johnson/Evinrude EU 25, 35 HP 3-Cylinder outboards Service Manual, Page 73Get this manual
Carburetor Mixture Adjustment
INote Before
proceeding, verify the low-speed needle initial settingRefer to Page 2-20, Step 9
1Start the engine and run it in FORWARD at one-half throttleAllow the engine to reach normal operating temperature2Tiller Modelsas you face the steering handle, turn the idle speed adjustment knob counterclockwise to full SLOW speed position
3Run the engine at slow speed (700-800 RPMI and adjust the low-speed needle until the highest consistent RPM is attainedAllow 15 seconds after each adjustment for the engine to respond4After the final adjustment is completed, turn the low-speed needle counterclockwise 18 turn to prevent lean condition, particularly in NEUTRAL5Reduce engine speed and turn the idle speed adjustment to allow the engine to run at minimum of 650 RPM in FORWARD6Run the engine in gear near full throttle for one minuteQuickly reduce speed to SLOW (700-800 RPM) and shift into NEUTRALThe engine should continue to run smoothly