1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 394Get this manual
Trim Sending Unit AdjustmentConventional It might be necessary to adjust the trim sending unit to coincide with the trim gauge at full trim-up positionTo do this, proceed as follows: 1Turn key switch to the ON position2Raise the engine with the tilt switch to maximum trim-up position3V4Move the angle adjusting rod to the center hole
rn 4Loosen thebesending unit screws until only snug, so the pivotedsending unit can
5V4Lower the engine all the way down against the angle adjusting rod
rn 7Observe the trim sendingIfunit needlepivoting it show gaugethe does not center positionadjust the by up or