1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 385Get this manual

1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 385

Belt Tension Procedure 1Be sure drive belt is in good condition and correctly routedBelt must engage all pulley grooves
rn 3Set adjustment rod for belt tension of 25-30 pounds
2Idler housing pivot screws must be loosened slightly
4Verify belt tension using ave Gauge, PIN 984850, midway between the idler and flywheel pulleysBelt tension is correct when the plunger is flush with the end of the handle 5Start engine and run it at 800 RPM for two minutesStop engine and repeat Steps and 4

Back to 1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269