1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 352Get this manual
r121 IJJ]
4Assemble armature to frame and magnet assembly, aligning marks on drive cap end and frame5Install insulated brush and terminal set in commutator end cap with long lead in slotPosition the insulators and nut as shown in figure
1Note Reversing these brushes will cause starter motor to run backwards
6Install brush holder, brush springs, and ground brushesScrews secure ground brush leads and holderInsert insulated brushes in holder7Assemble end cap to frame and field, aligning notch and ribA suitable tool for holding brushes in place can be made from putty knifemotorInstall thru-boltsTorque thru-bolts to 95-100 inIbs(11 -12 Nm)Seal with ave Black Neoprene Dip9Install pinion base and pinion on armature shaft10Install spacer and spring on armature shaft