1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 326Get this manual
1141 [lID [j]
21Push the propeller shaft out of the bearing housing22Remove thrust bearing and thrust washer
23Remove the seal using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131Position plate on top of housing to support bridge and tighten jaws securely behind the sealreason, it must be replaced
INote Inspect bearings in placeIf bearing is removed for any
24Remove either bearing using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Rest puller plate on top of housing to support bridge and tighten jaws securely behind bearing25Clean housing and bearings in solvent and dry thoroughlyIf bearings were not replaced, rotate needles with your fingers to check for freedom of movementInspect O-ring groove and sand off any sharp edges that would cut O-ring and prevent its sealing