1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 312Get this manual
COB3128
rn 8.Needle Bearingreassembly Grease shiftthe detent ballapply To begin the of the mechanism, ONIC Assembly to and
springInsert the ball and spring into the bearing housing
rn detent lever in position shown, depresssafetyball and spring &9To avoid personal injury, wear glassesWith the the
with punch while pushing the detent lever into the housing
10Position the shift lever in the housing, then rotate the detent lever to engage the shift leverInstall the pin through the housing and shift leverNext, push the detent lever down all the way
[] 11Apply ONIC Needle Bearing Assembly Grease to the 25 forward gear needle bearings and position the bearings in the bearing race12Apply ONIC Needle Bearing Assembly Grease to the shifter shaft, then install the cradle and shaft assembly on the shift lever
13Apply liberal amount ofONlC Needle Bearing Assembly Grease to the thrust bearing and thrust washerInstall the thrust bearing on shoulder of the forward gearInstall the thrust washer on shoulder of the bearing housingPlace the forward gear into the bearing housingMake sure the thrust bearing is between the thrust washer and forward gearNotel Bearing shown