1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 307Get this manual
7Install new seal in rear ofthe bearing housing using OMC Seal Installer, PIN 341439Apply DPL Penetrating Lubricant to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply OMC Triple-Guard grease to the seal lips after installing8Lightly apply OMC Triple-Guard grease to new bearing housing a-ringsInstall the a-rings and set the bearing housing retainers and screws aside42310
Driveshaft Bearing Housing Service
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged[] 1Remove the driveshaft bearing housing seal using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Discard the seal2Remove the a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove14155