1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 290Get this manual
Driveshaft Servicing
1To separate the upper driveshaft from the lower driveshaft, remove the roll pinReplace the damaged component
m theTo assemble theupper driveshaftthe driveshaft retainer 2driveshaft, install into groove of the rn 3Install holes upper driveshaft into the lower driveshaft, the aligning the in the driveshaft retainer and the lower
driveshaft
rn 4Install the roll pin to the dimension shownDriveshaft Shimming Using Tool, PIN 393185
The driveshaft pinion is precisely meshed with the forward and reverse gears by using one or more shims between the driveshaft bearing housing and the thrust washerWhen installing new thrust bearing or washer, bearing housing, pinion, or driveshaft, it is necessary to properly shim the assembly to restore factory clearanceGauge bars are precision made and should be handled carefullyThe length of each bar is stamped near the part numberThis dimension is 0.020 in(0,508 mm) shorter than the actual shimmed length of the driveshaft