1997 Johnson Evinrude "EU" 125C, 130, 200, 225, 250 90 LV Service Manual, P/N 507269, Page 279Get this manual
[] 5Install the water tube grommet with the inside taper facing up m m
6Install the impeller housing cover
7Apply ONIC Adhesive sealant to flat side of the impeller housing grommet CDInstall the grommet, flat side down
[] 8Lightly coat the liner with oilWith counterclockwise rotation, install the impeller into the liner with slot for impeller cam facing out[] 9Run thin bead of ONIC Adhesive sealant in the seal groove, and install the special shaped a-ring seal Q)Installation
rn impeller plate gasket InstallCompound andboth sidesplate 1Apply ONIC Gasket Sealing to of the gasket impeller newrnSlide the ONIC Triple-Guard grease to until impeller a-ring 2Apply new a-ring down the driveshaft it contacts the
impeller plate[] 3Apply ONIC Needle Bearing Assembly Grease to flat area of the driveshaftInstall the drive camThe sharp edge of the cam is the leading edge during driveshaft rotation (1)4Slide the water pump assembly down the driveshaftAlign slot in the impeller with the impeller camRotate the driveshaft to engage the impeller cam with the impeller, and slide water pump assembly down over impellerBe sure impeller cam does not fall out of position