1997 "EU" Johnson Evinrude 5 thru 15 Four Stroke Service Manual, P/N 507262, Page 142Get this manual
8 38158 42021
rn 8Inspect valves attention to the valveexcessive replaceor for contamination, wear, damagePay particular seat face, if
pittedValve stems that show excessive wear or are warped should be replaced[] 9Use micrometer to measure the camshaft lobesRefer to Engine Specifications, Section 1, for dimensions
rn rn Important
10Inspect rocker arms for contamination, excessive wear, or damageSome wear to the face of the rocker arm is normalReplace if wear is severe enough to show porosity (pitting) on the face
11Use micrometer to measure the diameter of each crankpin and main bearing journalRefer to Engine Specifications, Section 1, for dimensions12Use telescoping gauge or inside reading micrometer to inspect each cylinder bore for an out-of-round, oversize, or tapered conditionBe sure the gauge or micrometer is perfectly square in the bore when measuring13Measure each cylinder in at least two areasMeasure each area twiceThe difference between the two measurements in each area is the cylinder out-of-round dimension The cylinder must not be out of round by more than 0.003 in(0,08 mm)