1997 "EU" Johnson Evinrude 5 thru 15 Four Stroke Service Manual, P/N 507262, Page 98Get this manual
Installation
[]] rnand Apply OMC NuttoLock to screws(9-12 ignition coil in 1Place position torque screws 84-106 inIbsNm)Connect
plug wires
2Apply OMC Nut Lock to screwsPlace power pack in position with lock washers and ground wires under bottom flangeTorque screws to 84-106 inIbs(9-12 Nm)
[]]3Connect primary (orangeblue) wire to ignition coil
4Push connector halves together and secure with retainerBundle wires and connector and secure with tie strap
5Place stator in positionApply OMC Ultra Lock to screws and install; do not torque at this timeRoute wire sleeve through clamp, apply OMC Nut Lock to clamp screw, position, and torque to 36-60 inIbs(4-6 Nm)
[] 6Use OMC Stator Alignment Guide Kit, PIN 342670, and OMC Locating Ring, PIN 334994, to properly position stator
7Install guide bridge on OMC Locating Ring, PI 334994, and secure with set screws