1996 Johnson/Evinrude Outboards 8 thru 15 Four-Stroke Service Manual, Page 218Get this manual
Assembly
Make no dry assembliesLubricate bearings, shafts, and gear with OMC Ultra-HPF gearcase lube
1Oil the small bearing and install it in the propeller shaft bearing housing using OMC Bearing Installer, PIN 339751Press against the lettered side of the bearing when installing
m 2Oil the large bearingBearing Installer, the propellerPress and install it in shaft bearing housing using OMC PIN 339751
against the lettered side of the bearing when installing []] 3Use OMC Seal Installer, PIN 342663, to install new seal in the rear of the bearing housingApply oil to the casing of the seal before installing Install the seal with the exposed lip facing away from the bearing housing Press the seal into the housing until the tool seatsApply OMC Triple-Guard grease to the seal lips after installing4Apply OMC Triple-Guard grease to new bearing housing O-ringPlace the O-ring in the bearing housing groove32560