1996 Johnson/Evinrude Outboards 8 thru 15 Four-Stroke Service Manual, Page 202Get this manual
Installation
1Apply OMC Triple-Guard grease to the steering handle sleeve and install it in bracket
2Attach steering handle to the bracket and route cable through grommetTighten the nut just enough so the handle will maintain any position
[]] rn on Thread anchor onto cable lever on linkagethread is 3housing until one exposed front endInstall throttle
[] 4Install throttle on powerhead with washers and screwInstall throttle cable anchor on powerheadTorque screws to 48-96 inIbs(5,4-10,8 Nm)[] 5Install ground (black) wire under bottom flange on power packApply OMC Nut Lock to screw and install, with lockwasherTorque to 84-108 inIbs(10-12 Nm)[] 6Install stop button black wire in connectorPush connector halves together and secure with retainerBundle wires and connector and secure with tie strap7Install lower engine covers and manual starter&