1996 Johnson/Evinrude Outboards 8 thru 15 Four-Stroke Service Manual, Page 197Get this manual
3.0" 1 58" 1.0PIPE
DRC5257
rn mounts To remove themake side mounts withoutthe dimenINotel upper damaging removal tool using the or housing,
sions shown in the illustration
rn PIN Use removal tool, Bridge, PIN with locknut, and Puller 9319874, from OMC Kit, 386631, upper mount screw small
and large diameter washer
10Insert screw through bridge, removal tool and mount with the large washer at topInstall small washer with nut under mountPull mount out of housingAssembly and Installation
1Apply OMC EPlWheel Bearing Grease to upper mountsInstall mounts with indentation in mount aligning with point on housingThe off-center hole in mount is positioned to the rear
[] 2Install the two lower side mounts, lower front mount, and shift rod grommet