1996 Johnson/Evinrude Outboards 8 thru 15 Four-Stroke Service Manual, Page 195Get this manual
Installation
rn 1and install it in bracketgrease to the steering handle Apply OMC Triple-Guard sleeve
2Attach steering handle to the bracketTighten the nut just enough so the handle will maintain any position
Replace the handle locknut if it has lost its locking feature
3Use OMC Pin Insert Tool, PIN 322697, to install the stop button black wire into the 3-pin Amphenol plug
[] 4Position the stop ground wire behind the port side of the ignition module and install the screwTorque to 48-96 inIbs(5,4-10,8 Nm)
5Thread anchor onto cable housing until anchor is lS in(3 mm) from aft end of housing threadsInstall screw and washer to retain the throttle cable anchorTorque to 48-96 inIbs(5,4-10,8 Nm)6Install the throttle cable clevis end onto the throttle arm