1996 Johnson/Evinrude Outboards 8 thru 15 Four-Stroke Service Manual, Page 175Get this manual
9Lubricate the cylinder walls with oilLubricate the inside surface of an expandable piston ring compressor and place the piston and rod assembly insideINotel Be sure the piston rings are at the prescribed angles per
rn 10block, the ring compressor with piston and rod on the Place cylinder and align with cylinder boreThe stamped arrow
on the piston crown and the "F" on the rod faces the flywheel endTap piston into bore with wood hammer handle end or equivalent[] 11If removed, install new crankshaft sleeve with O-ring on end of crankshaft using ONIC Crankshaft Sleeve Installer, PIN 342662, until seatedApply ONIC Moly Lube to the O-ring
12Lubricate new bearing halves with oil and install in cylinder block with bearing edge flush with block