1996 Johnson/Evinrude Outboards 8 thru 15 Four-Stroke Service Manual, Page 143Get this manual
5Install OVIC Crankshaft Pulley Nut RemoverInstaller, Pi 342212, on crankshaft taper aligned with keyway and secure in place with flywheel nutUse crowfoot wrench to torque nut to 17-18 ftIbs(23-24 Nm)
[] 6Remove screw from the end of the camApply OVIC Nut Lock to screw and, with tool on crankshaft to prevent rotation, torque to 84-106 inIbs(10-12 Nm)Valve Lash Adjustment INotel Motor must be cold to adjust valve lashValve lash adjustment must be made with motor in timed position as described in Timing Procedure, this section
[] 1Set tappets for No.2 piston using OVIC Tappet Adjustment Tool, PIN 341444, and feeler gauge: Exhaust (upper rocker)0.006 in(0,15 mm) Intake (lower rocker)0.004 in(0,10 mm) Torque tappet nuts to 10-20 inIbs(1,1-2,3 Nm)2Rotate crankshaft pulley clockwise one revolution (360)This will rotate camshaft pulley one-half revolution (180) so the pointer faces opposite the extrusion on the manual starter boss3Set tappets for No1 piston in same fashion to the same specifications as No.2 piston[] 4Place new valve cover seal in the valve coverPosition cover, with bracket, on the cylinder head and apply OVIC Gasket Sealing Compound to the screwsTorque to 84-106 inIbs(10-12 Nm) in stages in the sequence shown