1996 Johnson/Evinrude Outboards 8 thru 15 Four-Stroke Service Manual, Page 142Get this manual
28Apply oil to and install new O-rings in the intake manifoldApply avIC Gasket Sealing Compound to screws and install manifold Torque screws to 84-106 in Ibs(10-12 Nm)
29Install the camshaft key with its outer edge parallel to centerline of camshaftInstall camshaft pulley on camInstall screw, with washer, in the end of the camDO NOT torque at this time 30Start crankshaft pulley on crankshaftInstall belt guide on top of pulley and thread nut onto crankshaftInstall the crankshaft key with its outer edge parallel to centerline to crankshaft
31 Install 0I'v'IC Crankshaft Pulley Nut RemoverInstaller, PI 342212, on crankshaft taper aligned with keyway and secure in place with flywheel nutUse crowfoot wrench to press pulley down in placeRemove nut and belt guide