1996 Johnson/Evinrude Outboards 8 thru 15 Four-Stroke Service Manual, Page 138Get this manual
[]] 8Position oil pump to match the slot in the shaft with the pin in the cam []] 9Apply OMC Gasket Sealing Compound to the oil pump
housing gasket and to the threads of the screwsPosition cover on pump housing and torque screws to 15-17 ftIbs(35-37 Nm)[]] 10If removed, apply OMC Gel-Seal II to the threads of the overboard water indicator nipple and torque to 20-25 inIbs(2,3-2,8 Nm)11Apply OMC Gasket Sealing Compound to casing of new camshaft sealand oil to the seal lips12Remove key from camshaft and place seal, casing up, on cam38437
INote When
starting seal over the cam, be sure the lips fit properly and the seal is square in the bore13Use OMC Camshaft Seal Installer, PI 342214, and hammer to tap the seal into placeTap until installer contacts the cylinder head40270