1996 Johnson/Evinrude Outboards 50 thru 70 3-Cylinder Service Manual, Page 234Get this manual
r,]l8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the slot of the pulley with the inner loop of the rewind spring and install the pulley in the starter housing f18111919Place the friction plate spri ng washer between the two friction plates on the pulley hubSecure the
friction plate and friction plate spring washer with the pulley lock ring
119110Be sure the starter pawl bushing is installed in the pulleyApply OMC Triple-Guard Grease or Lubriplate 777to boss of
the starter pawlPlace spring washer on the boss of the starter pawlPlace the starter pawl in the pulleythe starter housing spring in the starter
f19111hOUSing
120112Install the starter pawl plate return spring on the starter
pawl plate CDPress the other end of spring on the boss of the pulleyPosition the starter pawl plate on the pulley
13Clean threads of the starter pawl plate retaining screw and nut to remove adhesiveInstall the starter pawl plate retaining screw Q) and washer into the starter housingTighten screw to torque of 10-12 ftIbs(14-16 Nm)Spray threads of starter pawl plate retaining screw that protrude through the starter housing and threads of the nut with OMC Locquic PrimerApply OMC Screw Lock to the threads of the nutInstall and tighten the nut securely