1996 Johnson/Evinrude Outboards 50 thru 70 3-Cylinder Service Manual, Page 222Get this manual
1509Align hole in the clutch dog with slot in the propeller shaft Install the clutch dog on the shaft with grooved end of the clutch dog facing toward forward end of the shaftholes in the shifter shaft, propeller shaft, and clutch dogWhen holes are aligned, insert the clutch dog pin into the clutch dog and shifter shaftSecure pin with new retainer springInspect the spring for overlapping or loose coils
f51l10Insert the shifter shaft into the propeller shaft, aligning
11Push the detent lever down into the REVERSE position152112Locate the propeller shaft assembly and align the forward
bearing housing with the detent lever CD toward the topBe sure the thrust bearing and thrust washer are properly positionedInsert the propeller shaft assembly into the gearcase, being sure to align the shift housing pin with hole in forward end of gearcase housing