1996 Johnson/Evinrude Outboards 50 thru 70 3-Cylinder Service Manual, Page 221Get this manual
Assembly 1Note
Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and In serviceable condition Refer to Cleaning and Inspection, Page 6-4
After the gearcase has been thoroughly cleaned and inspected, install new pinion bearing in the gearcase as follows:
1Assemble the following components of OMC Pinion Bearing Remover and Installer, PIN 391257, as shown
x 12 inHex Head Screw PIN 326584 Spacer in0 .0Flat Washer PI 326582 Rod PI 326575 Installer -20 inHex Head Screw PI 391260 Plate 2Place the bearing on the installer tool with the lettered side of the bearing facing the toolUse OMC Needle Bearing Assembly Grease to hold the bearing on the tool3Insert the tool with the bearing into the gearcaseDrive the bearing into the gearcase until the washer on the tool contacts the spacer