1996 Johnson/Evinrude Outboards 50 thru 70 3-Cylinder Service Manual, Page 191Get this manual
15Slide the thrust washer onto the steering shaftSlide the steering shaft into the swivel bracketj28j16Thoroughly clean splines of the pivot shaft and lower mount bracketSpray splines with OMC Locquic PrimerPlace the keeper in the lower mount bracketApply OMC Nut Lock to splinesSlide the lower mount bracket on splines of pivot shaft aligning the steering arm forward and end of bracket aftInstall new nut with its unstaked side facing the mount bracket and torque to 190-210 ftIbs(258-285 Nm)17Lubricate the swivel bracket assembly through the grease fitting with OMC Triple-Guard grease2918The radius of the mount should be facing downInstall the two washersone retaining plateand two splined screws into the mou ntSeat both of the spli ned screws into the mount 3019Install the dowel into large bottom hole of the mountf31l20Install upper mount assembly to the steering armInstall nuts and torque to 30-32 ft.lbs(41-43 Nm)21Install the ground lead to the plate