1996 Johnson/Evinrude Outboards 50 thru 70 3-Cylinder Service Manual, Page 160Get this manual
Assembly
fN=J Proceed slowlyMake no forced assemblies unless press-
ing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INotel Use new gaskets, seals, and O-rings during assembly
Apply OMC Needle Bearing Grease to the 28 wrist pin bearingsInstall the bearings in the wrist pin boreAlign the bearing in the bore using OMC Wrist Pin Bearing Tool, PIN 3366601al2Place the two wrist pin thrust washers on the tool with flat side of the washers facing out