1996 Johnson/Evinrude Outboards 50 thru 70 3-Cylinder Service Manual, Page 151Get this manual
Powerhead ServicingAll Models Removal
ill twist and remove all spark plug leadsOn electric start
models, disconnect the battery cables at the battery
'" To avoid accidental starting of the engine while servicing,
1Rope St art modelsremove the starter assemblyRefer to Section 7
ill 2Remove three screws and remove the starter ratchetf21 3Remove the starter lockout cable clamp and disconnect the cable from the shift leverf21 4Tiller modelsremove the throttle cable pivot cable bracket 5Disconnect the shift lever 6Remove the stop switch ground lead and remove the stop switch lead from cavity "E" of the stator 5-pin Amphenol connectorUse OMC Pin Remover, PIN 322698, and isopropyl alcoholrJl 7Cut the tie straps and remove the hoses from the manual primer assembly8Remove the shift rod screw9Remove the fuel inlet hose from the fuel pump 'sl 10modelsremove the retaining clip and push the shift linkage toward the powerhead to release the shift rod TTL modelsremove the shift rod screw25073