1996 Johnson/Evinrude Outboards 50 thru 70 3-Cylinder Service Manual, Page 127Get this manual
6 DR4772
7Disconnect the 5-pin Amphenol connector between the stator and power packAttach jum per lead to power coil terminals "c" and "0" in the stator end of the connector
8Calibrate ohmmeter on appropriate scaleAlternately, attach meter leads between termina ls "C", "0", and clean engine ground Meter must show high reading
9Attach meter leads to power coil terminals
If meter shows 400 40 ohms, replace power pack If your test results vary, replace stator
INote Do not run the engine with its power coil