1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 289Get this manual

1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 289

Hydraulic Unit Servicing Removal 1Raise the motor and engage the trailering levers2Remove the blue and green wires from pump motor connector housing

3Remove the spring clip from the cylinder pin
4Thread ONIC Slide Hammer Adaptor, PIN 340624onto Q1C Slide Hammer, PIN 391008 Screw the adaptor into the cylinder pin and remove the pin
[[] 5Remove one of the 3f4 inlocknuts from the angle adjustment rodRemove the rod from the stern brackets
6Remove the unit from the stern brackets far enough to remove the ground lead from the pump motor mounting screw
Disassembly Thoroughly clean unit before disassemblingScrub all outside surfaces with stiff bristle brush and hot soapy waterThis will prevent dirt particles or other foreign matter from entering the unit while you are working on it