1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 204Get this manual
rn Hammer, PINBearing Puller, PIN the forward bearing OMC Use OMC attached to Slide to remove cup15 432130, 432128, Secure the puller jaws into grooves behind the cup with jaws facing port and starboardUse OMC Wrench, PIN 334359to hold the puller while tightening the jaws
[] 16Use OMC Puller Bridge, PIN 432127, and OMC Small Puller, PIN 432131, to remove the driveshaft seals from the gearcase
INote Inspect bearings in placeIf bearing is removed for any
reason, it must be replaced17Remove the upper driveshaft bearing and bearing sleeve from the gearcase using the same two toolsDiscard the bearing
18To remove the pinion bearings, assemble the following components from OMC Universal Pinion Bearing Remover and Installer, PIN 391257:
PIN 326582 Rod PI 326583 Pilot Plate PIN 326577 Remover and Installer -20 12 inHex Head Screw -20 inHex Head Screw CD in0.0Flat Washer