1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 151Get this manual
7Connect the low oil light lead to the engine harnessSecure the connector to the ignition module
8Install the starboard lower motor cover
9Attach the steering arm to the tiller armSecure with two screws and washersTighten the screws to 216-240 inIbs(24-27 Nm)Thread two lock nuts onto the threaded ends to the two tiller arm screws and tighten to 216-240 inIbs(24-27 Nm)10Place the shift and electrical cables in the lower motor cover grommet and secure in place in the lower motor cover11 Apply CWIC Locquic Primer to the two trunnion anchor screws and allow to air dryApply CWIC Nut Lock adhesive to the screwsAttach the trunnion anchor block to the crankcase and secure with the two screws Tighten the screws to 84-106 inIbs(9-12 Nm)lever using CWIC Ball Socket Installer, PIN 342225Attach the shift cable to the shift lever and secure with clip