1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 132Get this manual
7Remove the two screws securing the electrical connector cover to the engineRemove the cover
[] 8Disconnect the stop switch wire connector Remove the stop switch wire from the ground stud]9Tiller Electric Models: Disconnect the 5-pin connector Q)
rn 10Tillerto remove the two neutral start switch wires from Electric Models: Use the appropriate Amphenol pin removal tool
the connectorMake sure to identify the pin locations for installation during reassembly[] 11Tiller Electric Models: Remove the neutral start switch lead from the ground stud
12Remove the throttle cable ball socket Q) from the ball on the throttle lever using OMC Ball Socket Remover, PI 342226Remove the clip securing shift rod to shift leverRemove shift rod from lever13Re move the two screws block to the engine