1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 116Get this manual
3 DR6212 DRC6014
STEPSTOP CIRCUIT TEST
To avoid possible shock hazard, do not handle ignition coil or spark tester during cranking tests
Elimination TestRope 1Disconnect and isolate the stop button ground lead from the powerhead
2Pull the engine over and observe results at spark tester: If spark now jumps sequentially at each gap, the problem is in the stop circuitGo to Ohmmeter TestStop Button If there is still no spark, go to STEPPOWER COIL TESTElimination TestTiller Electric
m rn 1the 6-pin Amphenol connectorconnector between start button and ignition moduleDisconnect 1-pin Amphenol Disconnect containing the blackyellow stop switch leadConnect