1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 108Get this manual

1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 108

9Remove screw retaining the ignition coil to powerheadRemove coil with spark plug wire
Installation

[] 1Apply OMC Locquic Primer and OMC Nut Lock to the ignition coil mounting screwPlace ignition coil in position and torque screw to 84-106 inIbs(9-12 Nm)

2Apply OMC Locquic Primer and OMC Nut Lock to three ignition module mounting screwsPlace ground wire Q) and lock washer under module mounting bossPosition the ignition module and torque screws to 84-106 inIbs(9-12 Nm)Place ground wire and lock washer into position and secure with screw CD tightened to 84-106 inIbs(9-12 Nm)3Install tanblack no-oil sender lead into 2-pin Amphenol connector using OMC Insert Tool, PIN 322697Connect 4-pin Ampheno connector to engine harness and secure on ignition module4Attach three primary wires to ignition coils:

Back to 1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual