1996 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 101Get this manual
Installation
1Install the flywheel key with its outer edge parallel to centerline of crankshaft and single upset mark facing down2Clean the crankshaft and flywheel tapers with CIVIC Cleaning Solvent and let dryThese surfaces must be clean and dry to allow proper locking of the tapers
]] 3Align the flywheel keyway and install flywheelCoat the threads of the flywheel nut with CIVIC Gasket Sealing CompoundInstall the nut and torque to 100-105 ftIbs(136-142 Nm) using the flywheel holding tool as drawn on Page 3-6 and three PIN 309492 screws from CIVIC Universal Puller Set, PIN 378103, or other suitable tool to hold the flywheel
INote After replacing any major ignition component, verify correct maximum spark advance using the procedure outlined in Section 1Encoder Servicing
rn Checkan accumulation ofdirt.the encoder for broken cracked the two windows of corners or Clean or replace the encoder if