1996 Johnson Evinrude "ED" Electric Outboards Service Manual, P/N 507119, Page 125Get this manual
Installation
1Put drop of oil on the wires and pull several inches of wire through the seal
2Thread wires through adapter and push seal into place
3Slide heat shrink tubes over RED and BLACK motor tube wiresCrimp motor tube wires to choke coil, RED to RED, and BLACK to BLACK with splices 43248
rn 4Slide sourcetubes over splices and shrink ith heat shrink suitable heat
5Solder splices
INote Use only rosin core solder
Do not use acid core solder
rn 6tubes aover choke coil wiresof motorSlide heat Install new O-ring in groove shrink7Crimp motor tube wires to choke coil, RED to REDand BLACK to BLACK with splices 8Solder splicesSlide heat shrink tubes over splices and shrink in place[] 9Pull GREEN ground wire terminal into adapterSecure GREEN wire to adapter with screw and lock washer10Pull wires to position choke coil in adapter11 Install motor tube to adapterSee Motor Tube Replacement Installation in this section