1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 394Get this manual
Trim Sending Unit AdjustmentFasTrak 1Tilt the engine and engage the mooring bracket
IJJ 2Temporarily, install PIN
387278 thrust rod in the No.3
rn 3Loosen thebesending unit screws until only snug, so the sending unit can pivoted4Disengage the mooring bracketLower the engine against the thrust rod5Observe the trim gaugeIf the needle does not show center positiontilt the engine up and adjust the sending unit by pivoting it up or down6Lower the engine against the thrust rod to verify adjustmentRepeat Step 5, if necessary7After adjustment is correct, tilt the motor up, tighten the two sending unit screws, and remove the thrust rodWhen the engine is returned to the customer, the trim limiter rod must be installed and in the same location as it was when the motor was brought in for serviceLeavi ng the tri Ii iter rod out, or changing the adjustment, could allow the motor to unexpectedly trim in too far and cause loss of control