1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 336Get this manual
r:J2l 12V8Position the detent lever in NEUTRALRest the cradle Q) on the shift shaft Q), then attach the cradle to the shifter armsFully depress the detent lever to hold the shaft and cradle in placef13l 13Place the thrust bearing on the back of the reverse gearSet the thrust washer CD on top of the thrust bearing14 14Insert the gear, bearing, and washer assembly into the bearing housingBe careful not to dislodge any of the loose needle bearings15Before installing the clutch dog, you must correctly identify which is the propeller shaft endLook for the words "PROP END" or the OMC part number; both are stamped on the forward lugs, which must face the rear of the propeller shaftOrient the clutch dog properly, align the clutch dog retaining pin hole with the slot in the propeller shaft, and slide the clutch dog onto the splines f'N'=J The clutch dog is not symmetricalIf it's installed backward