1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 329Get this manual
1141 [1ID
21Push the propeller shaft out of the beari ng housi ng22Remove thrust bearing
and thrust washer
23Remove the seal using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131Position plate on top of housing to support bridge and tighten jaws securely behind the seal
INotellnspect bearings in placeIf bearing is removed for any reason, it must be replaced24Remove either bearing using OMC Puller Bridge, PIN 432127, and OMCLarge Puller Jaws, PIN 432129Rest puller plate on top of housing to support bridge and tighten jaws securely behind bearing25Clean housing and bearings in solvent and dry thoroughlyIf bearings were not replaced, rotate needles with your fingers to check for freedom of movementInspect O-ring groove and sand off any sharp edges that would cut O-ring and prevent its sealing