1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 325Get this manual
15Pull the clutch shaft out of the housing and slide the clutch dog off the rear of the shaftThe detent balls inside the rear of the shaft are not serviced and are available only as an assembly with the clutch shaft1141 16Lift the reverse gear
, thrust bearingand thrust washer off the bearing housing
Do not remove the bearing inside the reverse gearIt is not serviced separately and is available only as an assembly with reverse gearPush the shifter pivot pin out of the housingPull out the shift shaft, cradle, and shifterLift shifter and cradle off shift shaftLift the shift shaft and cradle out of the housingRemove the pivot pin and the shifter out of the housing19Remove the 25 loose needles from inside the bearing housing"" To avoid personal injury, wear safety glassesThe detent ball and spring can come out with great force while removing the detent