1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 310Get this manual
5Install new seal in rear ofthe bearing housing using OMC Seal Installer, PIN 341439Apply oil to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply OMC Triple-Guard grease to the seal lips after installing[] 6Lightly apply OMC Triple-Guard grease to new bearing housing a-ringsInstall the a-rings and set the bearing housing retainers and screws asideDriveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged1Remove the driveshaft bearing housing seal using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Discard the seal2Remove the a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove[] 4Install new seal in the bearing housing using OMC Seal Installer, PIN 341439Apply oil to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply OMC Triple-Guard grease to the seal lips after installing[] 5Lightly apply OMC Triple-Guard grease to new a-ringInstall the a-ring in top groove of the bearing housing42310