1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 309Get this manual
25If the water intake screen cannot be unplugged by cleaning, replace it:
Remove screw on starboard side of gearcase above screenPlace screwdriver on each side of the intake screen under the locating tabsSimultaneously, press screwdrivers in and up on both sides to free the screen
Install new screen:
Place port side in first, wide end downPush down and to the side until screen bottoms in cavityPlace starboard side in, and press down until screen snaps into placeMake sure both sides are in proper positionReinstall screw
Propeller Shaft Bearing Housing Service
1Remove the seal using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131Position the plate on top of the housing to support the bridge, and tighten the jaws securely behind the sealreason, it must be discarded
1Note Inspect bearings in placeIf bearing is removed for any