1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 295Get this manual
Assembly Note Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and in serviceable conditionRefer to Cleaning and Inspection IT]
1Assemble the following components of OMC Pinion Bearing Remover and Installer, PI 391257, as shown:
114-20 112 in Hex Head Screw in0.0Flat Washer PIN 326584 Spacer PI 3265741nstallerRemover PIN 326587 Washer (1I16 inx 1314 in0.0 PI 391260 Plate and Bearing PI 326582 Rod 114-20 1114 inHex Head Screw
2Apply OMC Needle Bearing Assembly Grease to the 18 need Ie bearings and insert them into the bearing case3Place the bearing on the installer tool with the lettered side of the bearing facing the top of the gearcaseUse OMC Needle Bearing Assembly Grease to hold the bearing on the tool
INoteIncorrect installation of the pinion bearing in the gearcase