1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 292Get this manual
[] 6Install new seal in rear of the bearing housing using OVIC Seal Installer, PIN 341439Apply oil to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply OMC Triple-Guard grease to the seal lips after installing II]
7Lightly apply OMC Triple-Guard grease to new bearing housing a-ringsInstall a-rings in its grooves in the housingDriveshaft Bearing Housing Service
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged[] 1Remove the driveshaft bearing housing seal using OVIC Puller Bridge, PIN 432127, and OVIC Large Puller Jaws, PIN 432129Discard the seal2Remove the a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove[] 4Install new seal in the bearing housing using OVIC Seal Installer, PIN 341439Apply oil to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply OMC Triple-Guard grease to the seal lips after installingDR5720